TV xStream Media

​​Description

TV xStream COMBO includes the USB Adapter, and Ethernet USB adapter for easy install. Plug and play installation 100% brand new and high quality. Wire your Fire TV device for a better internet connection. Supports 10/100 Mbps auto-sensing capability USB 2.0 interface Supports Auto MDIX (straight and cross network cable auto-detection) Support s USB full and high speed modes with bus power capability IEEE 802.3, 802.3u, and 802.3ab (10Base-T, 100Base-tx, and 1000 Base-T) compatible Supports both full-duplex and half-duplex operation in fast Ethernet Supports Jumbo packet of up to 9KB Supports suspend mode and remote wake-up via link-up and magic packet Female RJ45 jack supporting Auto MDIX Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering

​

Instructions

Plug your amazon power cable into the OTG adapter (included), plug in the other end of the OTG cable into your Amazon fire device (not 4th Gen cube). You now have a USB to connect the LAN Ethernet adapter to.  Connect your ethernet cable to the adapter and your router. wait 1 minute for connection.

 

TROUBLESHOOTING.

Power fire device off. Make Ethernet cable connection prior to plugging in power. Allow fire stick 10- seconds to turn on. wait 1-2 minutes to wired connection to complete. Verify by selecting setting>network.

 

If you see WiFi networks verify you do not have a 1st gen stick as the adapter is not compatible with 1st Gen sticks. To check your stick, remove it from the TV and turn it over. on the back of the stick look for these numbers...

1st-gen = 2ABDU-0509
2nd-gen = 2AE6S-0948

​

If you have a 2nd Gen stick or higher, connect everything one more time...Please wait no 1 hour and not all sticks will connect within a few minutes. If after 1 hour please contact us so we can help further

​

Available on Amazon, ebay and all good retailers.

​

Become an authorized seller - Contact us today

​

​